- Next we need to add our camshaft
gears to all the camshafts.
Again with our top-level assembly open insert
components and browse for the cam gear auto part
and go ahead and open that.
Now we will add a single instance only to the graphics view
even though we do need more, but we will make use
of the Copy with Mates command
to speed up our assembling process.
Let's get this gear into position using the Mate command.
Make these two faces concentric and flip alignment,
then add a Coincident Mate to these two faces.
Let's make two of the drilled
holes concentric to the flange.
And we should now have all three holes lined up.
If all is good, okay to complete the command.
Next we will copy this gear with
Mates to the other camshafts.
So select the gear, select the Copy with Mates command
and notice that as you select the selection box
you can see in the graphics view the mated faces.
And all you need to do is select the
corresponding faces on the relevant camshaft.
Now I'll get this one established.
And that is looking good so I'll leave it to you
now to go through the same procedure for the other
two shafts for additional practice.
Now the final components to add to complete the
design is the chain sub-assembly which I've already prepared
for you and we'll go ahead and do that in the next video.