- [Instructor] Now that I have all my primary slabs,
secondaries and tertiary surfaces in,
I'm going to go through and start
trimming away the material that I no longer need.
Everything's been overbuilt and now I just need to
trim everything back.
And for that I'm going to use Trim Sheet.
I'm going to specify the top primary slab first and,
for the boundaries,
I'm going to pick a bunch of edges, so I'm going to change my
type filter here to Edge
and start picking these edges, and then work your way
around the part.
Come over to this side.
And check my region.
That's the region that I want to keep.
Everything looks good.
Apply.
And basically do the same thing, working my way
around my part.
Pick my face.
Boundary.
Make sure Edge is still selected.
It should still be from the last time you had it there.
Pick those edges.
Region is good.
And apply.
Boundary.
Apply.
Got one more in this corner.
Now, to finish this one off, rather than doing
multiple trims, I just come to this end
and pick this edge on that as well.
And my last blend.
Hit my apply.
Everything checks out.
Good.
Everything's nicely trimmed.