Now, I want to go through
and create the top and bottom blends.
First, the top blend.
This can be created using a tool called a Styling Fillet,
and to do that,
I'm going to clean up the screen a little bit.
I'm just going to go ahead
and hide all of the meshes that I don't need,
and we'll also clean up the curves.
So we're going to frame in the initial blends
using that Styling Fillet tool.
I'll go ahead and double-click on it,
and pick my end-cap to that top surface.
Let me reverse the direction,
and I want to make sure that Variable is turned off.
I want to make sure G2 is selected.
I want to make sure that the arrows are pointing in,
and I want to have a Chordal Fillet going through that.
And I can begin typing in some numbers here.
Let's see if that matches up.
20's a little large.
Let me go down a little bit.
Let me try 10, little small.
And we'll go up to 15, and see what that looks like.
So it looks like it matches up pretty good.
Other thing I want to make sure I don't have turned on is
I do not want to trim these surfaces,
so I'm going to leave the Trim Supports turned off.
Select okay to create that blend.
I'll do the same thing on the opposite side.
Surface 1, reverse.
Surface 2, reverse.
And put in a value.
This is obviously going to be a little bigger.
40's a little large.
I'll back down a little bit.
I'll go down to 35 and work my way
into that fillet once again.
Everything looks good.
The final fillet is this one on the outside here,
and this tapers as it runs towards the rear of the vehicle.
So I'll pick my main slab, reverse.
Main slab, reverse, and this time,
I do want to turn on variable radius.
At this end,
I know I had a 35 millimeter radius capping this off.
At this end,
I know I had a 15 millimeter radius capping it off.
So I'll just double click on this end,
and turn my 15, and apply, and see what we have.
And we have our see-through peek-a-boo of the mesh.
We can see that it lines up pretty good.
I like it, so I'm going to keep it.
Select okay, and cancel.
And as you can see,
I have my three Styling Fillets set and ready to go.