[Narrator] Now I want to create the slabs
for the front
and the ends.
I'm going to go ahead and hide
the two slabs that I've created already.
And next step is to go in
and sight down the direction
you want to create your slab in,
which is going to be down the Y.
And, before I create that new slab,
I need to right mouse click on the compass
and I want to take my privilege plane
and make it my ZX plane.
Once that is set,
I can now draw in the planer patch
that I need
for that front.
Next thing I'm going to do is
change my distance analysis again,
just double click on that.
My surface is this.
My target is this.
The front, select OK and
proceed to fit to geometry.
I want to fit this
to this target.
I have really good deviation,
less than a quarter of a mil
and select OK.
Now I want to do the ends.
So, once again, I want to sight down
and click on my X,
right mouse click, this is my YZ plane
and draw in
my
planer patch.
Since I'm going to use two of these,
I'm going to take this
and I'm going to control C
on the keyboard for copy
and control V on the keyboard to paste.
So now I have those two.
Once again, I'm going to modify
my distance analysis
double-click on that,
surface number five and, for my target,
I'm going to use...
I could use either one.
Let's go to this end, forward end,
and select OK.
Fit to geometry.
Three by three, everything looks really good.
I'm going to double click
on my distance analysis,
once again, change it to the new surface,
to the new scan,
on the aft end,
and fit to geometry one more time.
Zoom in, take a look
and once again, everything's really close,
looks fabulous,
and select OK.
And there, we have all of our primary slabs.
Let me go ahead and show these,
so we can see,
our good work.